Introduction

A -

Length between the two locking holes

3.Check the installation diagram and mark the drill points on the wall. Use the 5.0 mm bit to drill holes deeper than 35 mm. Fix each anchor in the corresponding hole. Match each of the brackets and hinge holes to the corresponding anchor holes and insert and tighten the 11 screws A.

To mount the product on the wall bracket

The shape of the product may vary depending on the model. (The assemblies of the plastic hanger and the screw are the same)

1.Remove the 4 screws on the back of the product.

2.Insert the screw B into the plastic hanger.

Notice

Mount the product on the wall bracket and make sure it is properly fixed to the left and right plastic hangers.

Be careful when installing the product on the bracket as fingers can be caught in the holes.