English - 10
➢
◆
Installing the Display on the Wall Attachment Panel
Wall Bracket

Components

Plastic Hanger: 4 Screw : 11
Screw : 4 Anchor : 11

Wall Bracket Assembly

Installation Notes

◆
Contact a technician for installing the wall bracket.
◆
Samsung Electronics is not responsible for any damages to the product or harm to customers when
the installation is done by the customer.
◆
This product is for installing on cement walls. The product may not stay in place when installed on
plaster or wood.
Hinge Accessories
➢
Refer to the correct installation guide according to your wall bracket.
1Insert and tighten the Captive Screw in
the direction of the arrow.
When done, mount the wall bracket on
the wall.
2Before drilling into the wall, check if the length
between the two locking holes at the back of
the product is correct.
If the length is too short or long, loosen all or
some of the 4 screws on the wall bracket to
adjust the length.
3Check the installation diagram and mark the drill
points on the wall. Use the 5.0 mm bit to drill holes
deeper than 35 mm.
Fix each anchor in the corresponding hole.
Match each of the brackets and hinge holes to the
corresponding anchor holes and insert and tighten
the 11 screws .
Continued...
Length between the
two locking holes
Captive Screw
Wall Bracket
Hinge (Right)
There are two hinges
(left and right). Use the
correct one.
Hinge (Left)
1Left: 1 Right: 1
◆
Only use the components and accessories shipped with the product.
BN68-01304D-00Eng 7/30/07 12:42 PM Page 10