BN68-00654A-01Eng 4/19/04 4:13 PM Page 11

Installing the Display on the Wall Attachment Panel

The exterior of the PDP may be different than the picture.

ENG

(Assembly and installation of the plastic hanger is the same.)

1Remove the screws from the back of the PDP.

PPM42S3Q

PPM50H3Q

PPM63H3Q

2Use the screws and assemble the plastic hanger.

Please ask the installers to install the wall mount bracket.

Please be sure to check if the plastic hanger is completely secured on both the left and right side after hanging the PDP on the wall mount bracket.

Please avoid catching your fingers while installing and adjusting the angle.

Please tightly secure the wall mount bracket to the wall to avoid injury from a falling PDP.

3Tighten the screws of the plastic hanger to the back side of the PDP.

PPM42S3Q

PPM50H3Q

PPM63H3Q

4Put the 4 pegs on the PDP in the grooves of the wall mount bracket and pull down on the PDP (!) to secure it to the wall mount bracket (@). Tighten the screws as shown (#) so that the PDP cannot be separated from wall mount bracket.

PDP panel

Wall

Wall attachment panel bracket

11