BN68-00654A-01Eng 4/19/04 4:12 PM Page 9

Inserting the Batteries in the Remote Control

ENG

You must insert or replace the batteries in the remote control when you:

◆Purchase the PDP

◆ Find that the remote control is no longer operating correctly

1Remove the cover on the rear of the remote control by pressing the symbol downwards and then pulling firmly to remove it.

2Insert two R03, UM4, “AAA” 1.5V or equivalent batteries taking

care to respect the polarities:

◆ - on the battery against - on the remote control

◆+ on the battery against + on the remote control

3 Replace the cover by aligning it with the base of the remote control and pressing it back into place.

Assembling the Stand-Base

Fit the Stand-Base into the guide hole on the bottom of the monitor and tighten the left and right sides using four screws for each side.

➢◆ Two or more people should carry the PDP. Never lay the PDP on the floor because of

possible damage to the screen. Always store the PDP upright.

◆ For the PPM63H3Q model, please see the instruction for the SMM6330 stand.

9