11
ENG
Installing the Display on the Wall Attachment Panel (continued)
➢The exterior of the PDP may be different than the picture.
(Assembly and installation of the plastic hanger is the same.)
1Remove the screws from the back of the PDP.
2Use the screws and assemble the plastic hanger.
3Tighten the screws of the plastic hanger to the back side of the PDP.
4Put the 4 pegs on the PDP in the grooves of the wall mount bracket and pull down on the PDP (!) to
secure it to the wall mount bracket (@). Tighten the screws as shown (#) so that the PDP cannot be
separated from wall mount bracket.
PDP panel
Wall attachment panel bracket Wall
☛◆Please ask the installers to install the wall mount bracket.
◆Please be sure to check if the plastic hanger is
completely secured on both the left and right side after
hanging the PDP on the wall mount bracket.
◆Please avoid catching your fingers while installing and
adjusting the angle.
◆Please tightly secure the wall mount bracket to the wall
to avoid injury from a falling PDP.
BN68-00700A-00Eng_0702 7/2/04 4:43 PM Page 11