Installing the Washing Machine
Connecting the water supply hose(Option)
1. Remove the adaptor from the water |
| 4. Connect the water supply hose to |
supply hose. |
| the adaptor. Pull down part (c) of the |
| c | water supply hose. When you |
| release part (c) the hose automa- | |
|
| tically connects to the adaptor |
|
| making a ’click’ sound. |
2. First, using a “+” type screw driver, |
| 5. Connect the other end of the water |
loosen the four screws on the |
| supply hose to the inlet water valve |
adaptor. Next, take the adaptor |
| at the rear of the washer. Screw the |
and turn part(b) following the |
| hose clockwise all the way in. |
arrow until there is a 5mm gap. |
|
|
3. Connect adaptor to the water tap by |
| |
tightening the screws firmly. | a |
|
Then, turn part (b) following the |
| |
arrow and put(a) and (b) together. | b |
|
NOTICE After completing connection, if water leaks from the hose, then repeat the same steps. Use the most conventional type of faucet for water supply. In case the faucet is square or too big, remove the spacing ring before inserting the faucet into the adaptor.
Positioning the drain hose
The end of the drain hose may be positioned in three ways:
Over the edge of a wash basin.
The drain hose must be placed at a height of between 60 and 90 cm. To keep the drain hose spout bent, use the supplied plastic hose guide. Secure the guide to the wall with a hook or to the faucet with a piece of string to prevent the drain hose from moving.
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60 cm above the ground.
ln a drain pipe
Samsung recommends that you use a 65 cm high vertical pipe; it must be no shorter than 60 cm and no longer than 90 cm.
SAMSUNG Washing Machine Owner’s Instructions 5
