Samsung RF26NEBP1/SML, RF26NBUS2/SML, RF26NBBP1/SML, RF26NESH1/SML manual Setting UP ThE Refrigerator

Models: RF26NBBP1/SML RF26NBBP2/SML RF26NBUS1/SML RF26NBSH2/SML RF26NEUS1/SML RF26NBSH1/SML RF26NBRS1/SML RF26NBUS2/SML RF26NEBP1/SML RF26NESH1/SML

1 32
Download 32 pages 39.28 Kb
Page 16
Image 16

Check the amount of water supplied to the ice tray. (Optional)

When you press the TEST button, the ice cube container is filled with water from the water supply tap. Check to make sure the amount of water is correct (see the illustration below).

If the water level is too low, the ice cubes will be small. This is a water pressure problem of the main water pipes, not the Refrigerator. If this problem occurs, contact the dealer or call center for help.

• TYPE A

Feeler Arm

Check the water level

Test button

1.Lift up the cover and pull the ice maker out of the freezer drawer.

TYPE B

Test button

Feeler Arm

1. Lift up the icemaker bucket and gently pull out of the refrigerator.

• When you have not used the Ice maker for a while, or you have opened the Freezer door frequently, the Ice may stick together. If this has occurred, empty the ice container or break

CAUTION up the ice with a wood kitchen tool. Do not use sharp items such as knives or forks.

Do not press the test button continuously when the tray is filled with ice or water as illustration below. Water may overflow or ice jamming may occur

SETTING UP ThE REFRIGERATOR

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance.

By completing the following steps, your Refrigerator should be fully operational. If not, first check the power supply and electricity source or try the troubleshooting section at the back of this user’s guide. If you have any further questions, contact your Samsung Electronics call center.

1.Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the Refrigerator. Refer to installation instructions in this manual.

2.Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.

3.Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly.

4.After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the

Refrigerator after the temperature is sufficiently cool.

16_Setting Up

Page 16
Image 16
Samsung RF26NEBP1/SML, RF26NBUS2/SML Setting UP ThE Refrigerator, Refrigerator after the temperature is sufficiently cool