Using the Ice & Water Dispenser together
To get Ice and water, push the Ice lever ( 1 ) first for ice, then move your glass down and press the water dispenser lever ( 2 ) for water.
MAINTAINING THE ICE BUCKET
•To clean the ice bin/bucket, wash with a mild detergent, rinse well, and dry thoroughly.
Do not use harsh or abrasive cleaners or solvents.
•Ice is made in cubes.
When you select “Crushed”, the ice maker grinds the ice cubes into crushed ice.
•When you select Cubed Ice after using the Crushed Ice mode, a small amount of residual crushed ice might be produced.
•The ice cubes generated by the rapid ice making process will look white, which indicates they are generated normally.
•If ice doesn’t come out, pull out the ice bucket and press the Test button located on the right side of ice maker.
See the illustration under Making Ice below.
•Do not press the Test button continuously if the tray is filled with ice or water.
Water may overflow or ice may jam the bucket.
MAKING ICE
•To fill the ice bucket to maximum capacity after installation, follow these steps:
1.Allow your refrigerator to operate and cool down for 24 hours (or 1 full day).
2.Dispense 4 to 6 ice cubes into a glass.
3.After another 8, and then 16 hours, dispense a full glass of ice.
•To test the ice maker, press the Test button on the ice maker.
You will hear the refrigerator chime
•The chime sounds automatically again to let you know the ice maker is working well.
Check the water level
Test button
•If you want to remove the ice cubes CAUTION without using the ice bucket, please turn
the ice maker off.
(However, remove the front cover from the ice maker.)
The ice cubes in the ice maker can spill out over the drawer.
•Do not put food in the ice bucket. CAUTION If you store food in the ice bucket, the
food may get in the way of the ice maker while opening/closing the door, causing damage to the ice maker.
•Note that the ice cubes in the ice bucket CAUTION may spill out over the drawer when
removing the ice bucket from the drawer. If this is the case, be sure to clear the ice cubes that spilled out of the drawer.
•If a power failure occurs, ice cubes CAUTION may melt then freeze together when
the power comes back on, causing the dispenser to be out of order.
To prevent this problem, after a power failure, pull out the ice bucket and discard the residual ice or water.
•If you use all the ice at once, you must repeat Steps 2 and 3 above. However, only wait 8 hours before dispensing the first 4 to 6 ice cubes. This will replenish the ice cubes and ensure maximum ice production.
English - 34
2017. 8. 8. |
��
9:20
