1.First, shut off the main water supply line.

2.Locate the nearest cold, drinking water line.

3.Follow the Water line Installation Instructions in the installation kit.

CAUTION

The water line must be connected to the cold water pipe. If it is connected to the hot water pipe, it may cause the purifier to malfunction.

Close Main Water pipe

Close Main

No gap

Water pipe

 

Connecting the water line to the refrigerator

1.Remove the cap from water line on the unit and insert compression nut to the water line on the unit after disassembling from provided water line.

2.Connect both water line from the unit and water line in the kit.

3.Tighten the compression nut onto the compression fitting. There should be no gaps between

(A, B & C )

4.Turn water on and check for any leakage.

Remove

Only connect the water line to a drinkable water source.

If you have to repair or disassemble the water line, cut off 6.5mm of the plastic tubing to make sure you get a snug, leak-free connection.

After the water supply has been installed CAUTION check all the joints to ensure there are no

leaks.

•Samsung Warranty does

not cover THE WATER

LINE INSTALLATION.

• The cost of the water line installation is at the

customers expense, unless the retailer has covered this expense in the delivery charge.

•Please contact a Plumber or Authorized Installer for the installation if needed.

•If Water leakage occurs due to improper installation, Please contact installer.

SETTING UP THEREFRIGERATOR

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.

1.

Place the Refrigerator in an appropriate location

 

with reasonable clearance between the wall and

 

the Refrigerator. Refer to installation instructions

 

in this manual. (P8. Selecting the best location for

2.

the Refrigerator)

Once the Refrigerator is plugged in, make sure

 

the interior light comes on when you open the

3.

doors.

Set the Temperature control to the coldest

 

temperature and wait for an hour. The Freezer

Loosen a

cap

will get slightly chilled and the motor will run

smoothly.

4. After powering the Refrigerator, it will take a few

hours to reach the appropriate temperature. You

Water Line

from unit

No gap

Water Line

from unit

can store food and drinks in the Refrigerator after

the temperature is sufficiently cool.

14_ setting up