Samsung RFG237AABP, RFG237AAWP Dispenser Insert the clip in the install pack and check that

REATTACHING THE REFRIGERATOR DOORS

4. Connect the water line ( 5 ) and then insert a clip	4	3
on the coupler with pulling tube. Connect the one
connector ( 4 ) on left side door, the other connector
( 7 ) on right side door and two connectors ( 3 ) at
each side of the top cap.			3
		7
The clip is enveloped inside of the top cap.
5

	• The Water Line must be fully inserted to the	Type A	Type B
CAUTION	center of transparent coupler (Type A) or the
	line (Type B) to prevent water leakage from the		Dispenser
	dispenser.
	• Insert the clip in the install pack and check that	Center of Transparent coupler
	it holds the line firmly.		The Guide Lines
		clip A (1/4”)	clip A (1/4”)
		(6.35mm)
			(6.35mm)

01 SETTING UP

5.Position the top table ( 2 ) in place. Insert and tighten the 3 screws into the top table with a philips screw driver(+). After door opened, reinsert the cap top table ( 1 ) and close the doors.

When reattaching the top table, make sure that the wires are not pressed or damaged by the hinge cover.

After assembling, close the door and check to see whether the door has gaps between gaskets or is tilted. If you see one of them, please refer to “Adjusting the doors” page on 15.

2

1

Setting Up _13

DA68-01827B-15.indb 13 13. 4. 24.

�� 11:30