Controlling the Refrigerator temperature
You can choose the type of ice by pushing the cubed or crushed button first.
The Refrigerator temperature can be set between 7ºC and 1ºC to suit your particular needs. Press the Fridge button repeatedly until the desired temperature is shown in the temperature display.
The temperature will move 1°C degrees with each press (3°C → 2°C → 1°C → 7°C → 6°C → 5°C → 4°C → 3°C). The temperature control process for the Fridge works just like the Freezer process.
Press the Fridge button to set your desired temperature. After a few seconds, the Fridge will begin adjusting towards the newly set temperature. This will be reflected in the digital display.
Using the Water lever ( 2 )
Push the Water lever dispenser ( 2 ) gently with your glass. Water will be released from the dispenser.
Even if you push the water and Ice lever simultaneously, the dispenser operates only the option you selected or pushed first.
1
2 
02operating
-The temperature of the Freezer, fridge or Convertible Room may rise when you open the doors too frequently, or if a large amount of warm or hot food is placed inside.
-This may cause the digital display to blink. Once the Freezer and fridge temperature return to their normal set temperatures, the blinking will stop.
-If the blinking continues, you may need to “reset” the Refrigerator. Try unplugging the appliance, wait for around 10 minutes and then plug the power cord back in.
-If there is an communication error between the Display and Main Controller, the Convertible Display light may blink. Once the normal set temperatures are reached, the blinking will stop. If the blinking continues for a long period of time, please contact a Samsung Electronics Service Center.
USING THE COLD WATER DISPENSER
Press the Ice / Water button to select the type of you want.
NO ICE Select this if you want to turn ice maker off
Using the ice lever ( 1 )
Push the Ice lever dispenser ( 1 ) gently with your glass. Ice will be released from the dispenser.
Using the Ice & Water Dispenser together
To get Ice and water, push the Ice lever ( 1 ) first for ice, then move your glass glass down and press the water dispenser lever ( 2 ) for water.
Do not pull the
CAUTION lever out. You could damage or break the
lever’s spring.
• | To clean the |
|
CAUTION | ice bin/bucket, |
|
| wash with a mild |
|
| detergent, rinse |
|
| well, and dry | Test button |
| thoroughly it. | |
|
| |
| Do not use harsh or abrasive cleaners or | |
| solvents. |
|
•When you select Cubed Ice after using the Crushed Ice mode, a small amount of residual crushed ice might be produced.
•In case ice doesn’t come out, pull out the ice bucket and press the test button located on the right side of ice maker.
•Do not press the test button continuously when the tray is filled with ice or water. Water may overflow or ice may jam the bucket.
•Normal Use
To fill the ice bucket to maximum capacity after installation, follow these steps:
1.Allow your refrigerator to operate and cool down for 24 hours (or 1 full day).
- Waiting 24 hours will allow your ice maker to cool properly.
2.Dispense 4 to 6 ice cubes into the glass.
3.After 8, and then 16 hours, dispense a full glass of ice.
operating _15
2016. 12. 2. �� 4:33 |
