SETTING UP THE REFRIGERATOR DOORS

If your entrance won’t allow the refrigerator to pass easily through it, you can remove the doors.

Separating the water supply line from the refrigerator

1.Pull the two water lines (which are in the Fixer) out to the front.

Center of Transparent coupler

Clip A (1/4”) (6.35 mm)

Do not cut the water line.

Gently separate it from the coupler.

Keep the clips out of the reach of children CAUTION and make sure that children do not play

with them or put them into their mouths.

setting up

2.Remove two water lines (White one is for water and the other one is for ice) by pressing the coupler ( 1 ) and pulling the water line ( 2 ) away.

DISASSEMBLE THE FREEZER DOORS

1.Disconnect the power cord, and remove 2 cover screws using a Phillips screwdriver ( 1 ).

Then open the refrigerator door and pull the hooks on the sides to loosen the cover

( 2 ).Lift up the cover and towards you to detach it ( 3 ).

CAUTION

CAUTION

( 1 )

Make sure the

 

colour of the water

( 2 )

lines match.

 

When reconnecting the supply hoses, make sure the same colored hoses are inserted with each other.

-- Detach the hinge cover with the door open and then close the door once the hinge cover has been detached.

( 1 )

( 2 )( 3 )

Reattaching the Water Supply Line

1.The Water Line must be fully Inserted to the centre of transparent coupler to prevent water leakage from the dispenser.

2.Insert the 2 clips in the install pack and check that each clip holds the line firmly.

English - 17

DA68-02976F-07.indb 17

2016. 10. 6. �� 3:00