Samsung RM25KGRS1/XET, RM25KGRS1/XEH manual Check the amount of water supplied to the ice tray

Models: RM25KGRS1/XET RM25KGRS1/XEH

1 40
Download 40 pages 46.07 Kb
Page 36
Image 36

Installation OF the water dispenser line

Remove any residual matter inside the water supply line after installing filter.

1)Turn on the main water supply & shut-off the valve of the water supply line.

2)Run water through the dispenser until the water runs clear (6~7 minutes). This will clean the water supply system and clear air from the lines.

3)Additional flushing may be required in some households.

4)Open the fridge door and check if water leaks around the water filter.

ICE

WATER

NOTE

A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser.

Check the amount of water supplied to the ice tray.

1) To remove : Set the type of ice to the “Ice Off” position.

Lift up () and pull out () the ice bucket in the freezer.

To replace : When replacing the drawer, be sure to press it firmly into place. If it does not go all the way back, remove it and rotate the drive mecha- nism 1/4 turn. Then push the drawer back again.

2)Throw away the first few batches of ice to allow the water line to clear.

Be sure nothing interferes with the sweep of the feeler arm.

When the bin fills to the level of the feeler arm, the icemaker will stop producing ice.

It is normal for several cubes to be joined together.

If ice is not used frequently, old ice cubes will become cloudy, taste stale and shrink.

ICE BUCKET

ICE MAKER

Feeler Arm

Rotate

Drive Mechanism

Place the ice tray at the originally provided posistion by manufacturer in order to achieve NOTE optimal ice-freezing.

36

Page 36
Image 36
Samsung RM25KGRS1/XET, RM25KGRS1/XEH manual Check the amount of water supplied to the ice tray