INSTALLING THE WATER DISPENSER LINE

For Exterior model

Connect to the water supply line

Connect the water pipe with coupler and tap.

-Close the main water tap.

-Connect coupler “A” to the tap.

-Every join should be protected with sealing tape.

WARRANTY INFORMATION

This water line installation is not covered by the refriger-ator or ice maker manufacturer's warranty.

Follow these instructions carefully to minimise the risk of expensive water damage.

Note:

If the coupler does not fit on the current tap, go

the nearest authorised service dealer and purchase the right couplers fittings.

CAUTION

The water line must be connected

to the cold water pipe.

If it is connected to the hot water pipe, it may cause the purifier to malfunction.

COUPLER “A”

TAP

Select the location where the purifier is to install. (Model with the purifier)

-Cut the water line attached to the purifier to the appropriate place after measuring the distance between the purifier and the

cold water tap.

PURIFIER

 

WATER

-If you wish to reassemble the water inlet and outlet sides of the purifier during purifier installation, see the reference illustration.

COUPLER

 

WATER INLET

90 degree

SIDE OF PURIFIER

 

Line outlet

REFERENCE

SIDE OF PURIFIER

Remove any residual matter inside the purifier. (Model with the purifier)

-Open the main water tap to check whether water is running through the water tube on the water inlet side of the purifier.

-If water does not come out through the line, check whether the tap is open.

-Leave the tap open until clean water is running out and any residual matter that built up during manufacturing has been removed.

WATER LINE

PURIFIER

OUTLET SIDE

WATER

 

OF PURIFIER

 

30

Page 30
Image 30
Samsung RS23FKMS1/BUL, RS23FCMS1/EUT manual Connect to the water supply line, Degree