2) When you press the test button, the ice cube container is filled with water from the water supply tap.
Check the amount of water (see the illustration below). If the water level is too low,
the ice cubes will be small.
This is not a problem with the ice maker CHECK THE WATER
but of the water pressure inLEVEL
the pipe, and occurs frequently. When this problem occurs, contact the dealer service center to check the amount of water supplied.
32
1) Lift up () and pull out () the ice maker bucket in the freezer.

INSTALLING THE WATER DISPENSER LINE

Remove any residual matter inside the water supply line

1)Turn on the main water supply & shut-off valve of the water supply line.

2) Run water through the dispenser until the water runs clear

ICE

(6~7 minutes). This will clean the water supply system and

 

clear air from the lines.

 

3)Additional flushing may be required in some households.

4)Open the refrigerator door and check if water leaks around the water filter.

WATER

• A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser. NOTE • Before reinstalling the water filter, remove the wine shelf.

Check the amount of water supplied to the ice tray.

ICE MAKER

TEST BUTTON

TOO HIGH

OPTIMUM-

LEVEL

TOO LOW

Page 32
Image 32
Samsung RS23FKMS1/BUL, RS23FCMS1/EUT manual Remove any residual matter inside the water supply line