INSTALLATION OF THE WATER DISPENSER LINE
Connect the water line to the refrigerator.
1)Slip the compression nut through the provided plastic tubing.
2)Tighten the compression nut onto 1/4” comprression fitting.
Refrigerator
Ferrule | Compression Nut (1/4 | |
(Purchased) | ||
(Provided) | ||
|
NOTE
Do not overtighten the compression nut.
Compression Fitting |
Using Copper Tubing
- Slip the compression nut and ferrule on cop- per tubing as shown.
Using Plastic Tubing
-Insert the molded end of the plastic tubing into the compression fitting.
3)Tighten the compression nut onto the com- pression fitting.
4)Turn water on and check for any leakage.
| (Provided) |
| Compression Nut (1/4 |
| (Purchased) |
Copper Tubing | Plastic Tubing |
(Purchased) | (Purchased) |
Household Water Line
Water line must be connected to drinkable water only.
NOTE Cut off 1/4 inch of the provided plastic tubing squarely to prevent leaks when reconnect.
Install the water filter.
1)As shown, the fixed cap separates from the refrigerator by rotating it counterclockwise.
Remove the water filter from the box and put a month indicator sticker on the filter as shown.
Keep the cap(A) in a safe place for recapping, when you will NOTE not use the filter.
2)If the water filter was installed in March, put on the "SEP" sticker.
3)Remove the protective cap then position and insert the filter as shown.
4)Slowly turn the water filter clockwise 90º to align
the indication mark on the cover, locking the filter in posi
tion. Do not overtighten.
SEPARATION
OF RED CAP
STICKER
(MONTH INDICATION)
Please check that the indication line aligns with the lock position.
NOTE
(A)
COVER FILTER
ALIGN THE INDICATION MARK WITH LOCK POSITION.
INSTALLATION INSTRUCTIONS
27
