Samsung RS2644SW, RS2545SH, RS2544SL, RS2666SW Installation Of The Water Dispenser Line, Too Low

Models: RS2777SL RS2622SW RS2666SL RS2644SW RS2644SL RS2666SW RS2544SL RS2545SH

1 32
Download 32 pages 52.94 Kb
Page 28
Image 28
INSTALLATION OF THE WATER DISPENSER LINE
2) When you press the test button, the ice cube container is filled with water from the water supply tap.
Check the amount of water (see the illustration below).
If the water level is too low,CHECK THE WATER LEVEL the ice cubes will be small. This is not a problem with the ice maker but of the water pressure in
the pipe, and occurs frequently. When this problem occurs, contact the dealer service center to check the
amount of water supplied.
28
1) Lift up () and pull out () the ice maker bucket in the freezer.

INSTALLATION OF THE WATER DISPENSER LINE

Remove any residual matter inside the water supply line after installing filter.

1) Turn on the main water supply & shut-off the valve of the water supply line.

ICE

2) Run water through the dispenser until the water runs clear (6~7 minutes). This will clean the water supply system and clear air from the lines.

3) Additional flushing may be required in some households.

4) Open the refrigerator door and check if water leaks around the water filter.

WATER

WATER • A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser. NOTE • Before reinstalling the water filter, remove the wine shelf (RS2666/2777).

Check the amount of water supplied to the ice tray.

ICE MAKER

TEST BUTTON

TOO HIGH

OPTIMUM

LEVEL

TOO LOW

Page 28
Image 28
Samsung RS2644SW, RS2545SH Installation Of The Water Dispenser Line, Ice Maker Test Button Too High Optimum Level, Too Low