Samsung RS275ACBP/XAA owner manual Check the amount of water supplied to the ice tray

INSTALLATION OF THE WATER DISPENSER LINE

Remove any residual matter inside the water supply line after installing the filter.

1) Turn on the main water supply & shut-off the valve of the water supply line.

ICE

2) Run water through the dispenser until the water runs clear (6~7 minutes). This will clean the water supply system and clear air from the lines.

3) Additional flushing may be required in some households.

4) Open the refrigerator door and check if water leaks around the water filter.

WATER

• A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser. NOTE • Before reinstalling the water filter, remove the wine shelf (RS277).

Check the amount of water supplied to the ice tray.

1) Lift (①) and pull out (➁) the ice maker bucket in the freezer.
2) When you press the test button, the ice cube container is	ICE MAKER
filled with water from the water supply tap.
Check the amount of water (see the illustration below).
If the water level is too low, the ice cubes will be small.
This is not a problem with the ice maker but of the water pres-
sure in the pipe, and occurs frequently.
When this problem occurs, contact a
service person to check the amount of
water supplied.

INSTALLATION INSTRUCTIONS

3) In case ice doesn't come out, pull out the ice bucket and press test button located on the bottom of ice maker.

CHECK THE WATER LEVEL

TEST BUTTON

TOO HIGH

OPTIMUM

LEVEL

TOO LOW

29