Samsung RSE8V manual Check the amount of water supplied to the ice tray, Installation Instructions

Models: DA68-01453B RSE8J RSE8D RSE8V RSE8T RSE8K

1 38
Download 38 pages 46.75 Kb
Page 32
Image 32
Remove any residual matter inside the water supply line
31
LEVEL
CHECK THE WATER
filled with water from the water supply tap.
Check the amount of water (see the illustration below). If the water level is too low,
the ice cubes will be small.
This is not a problem with the ice maker but of the water pressure in
the pipe, and occurs frequently.
When this problem occurs, contact the dealer service center to check the amount of water supplied.
1) Lift up () and pull out () the ice maker bucket in the freezer.
2) When you press the test button, the ice cube container is

INSTALLING THE WATER DISPENSER LINE

Remove any residual matter inside the water supply line

1) Turn on the main water supply & shut-off valve of the water supply line.

2) Run water through the dispenser until the water runs clear ICE (6~7 minutes). This will clean the water supply system and

clear air from the lines.

3)Additional flushing may be required in some households.

4)Open the refrigerator door and check if water leaks around the water filter.

WATER

• A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser.

NOTE

Check the amount of water supplied to the ice tray.

ICE MAKER Check the amount of water supplied to the ice tray.

TEST BUTTON Manual background

TOO HIGH

OPTIMUM-

LEVEL

TOO LOW

INSTALLATION INSTRUCTIONS

Page 32
Image 32
Samsung RSE8V, RSE8K, RSE8T, RSE8D Check the amount of water supplied to the ice tray, Installing The Water Dispenser Line