CHECKING THE WATER DISPENSER LINE (OPTIONAL)
1)In order to operate the ice maker properly, water pressure of 1.4 ~ 10 kgf/cm2 (0.14 ~ 9.8Mpa, 19.9 ~ 142.2 psi, 1.37 ~ 9.8 bars) is required.
In this range a 100 cc paper cup can be filled in 10 seconds.
2)The water filter removes particles. It does not sterilize or destroy any
3)If the refrigerator is installed in an area with low water pressure (below 1.4kgf/cm2 (0.14 Mpa, 19.9 psi,1.37bars)), you should install a booster pump to compensate for the low pressure.
4)Ensure the water storage tank inside the refrigerator is properly filled initially. Push the water dis penser lever until the water runs from the outlet.
| A universal water supply kit is available at extra cost from your dealer. The refrigerator manufacturer |
NOTE | recommends using a water supply kit containing copper tubing. |
|
Checking the Parts
Purifier | Water line | Valve water fitting |
Sealing tape
Tapping screw x 12EA | Clip A x 12EA |
(Connector Water Filter Assy)
INSTALLING OF THE WATER DISPENSER LINE
(Case 1)
Connecting to water supply line | 1. | Cold Water line |
| ||
- Shut off the main water supply line and turn the Ice | 2. | Pipe Clamp. |
3.Copper (or Plastic) line | ||
maker to the off position. | 4.Compression Nut | |
- Locate the nearest cold drinking water line. | 5.Compression Sleeve | |
- Follow the instructions in the ice maker installation kit. | 6.Shut Off Valve | |
| 7.Packing Nut. | |
28
