USING THE ICE MAKER

To Remove the Ice Bucket

-Hold the handle as shown in fi gure1.

-Slightly pull up the bottom part.

-Take out the ice bucket slowly.

To Refit The Ice Bucket

-Assemble it in the reverse order of disassembly.

-Push the bucket in fi rmly until you hear a clicking sound.

-When the bucket does not fi t into its place, turn the gear handle on its back by 90 degrees and reinstall it again as shown in fi gure 2.

Normal Operation

-Any sounds you hear when the ice maker dumps ice into the bucket are part of normal operation.

-Not dispensing ice for long periods may cause ice clumps in the ice bucket. Remove the remaining ice and empty the bucket.

-When ice does not come out, Check for any ice stuck in the chute and remove it.

-The fi rst batch of ice cubes may be small due to air in the pipe after connection, any air will be purged during normal use.

-When ICE OFF blinks on the display panel, reinsert the bucket and/or

make sure it’s installed properly.

CAUTION

-When the door is open, the Ice and water dispenser do not work.

-If you close the door hard, it may cause water spilling over the ice maker.

-To prevent dropping the ice bucket, use both hands when removing it.

-To prevent injury, be sure to clean up any ice or water that may have dropped on the fl oor.

-Do not let the children hang on the ice dispenser or on the bucket. They may get hurt.

-Be sure not to put your hand or any object into the ice chute.

It may cause personal injury or damage mechanical parts.

28_ operating

Figure1

Figure2

Ice Chute

DA99-01746A(EN)-1.7.indd Sec4:28

2013.2.28 10:14:50 AM

Page 28
Image 28
Samsung RSG257AAWP, RSG257AARS user manual Using the ICE Maker, To Remove the Ice Bucket