-Remove the compressor cover of the refrigerator.
-Connect the water line to the valve, as shown in the fi gure.
-When connected, check if there is any leakage. If any, repeat the connection.
-Reattach the compressor cover of the refrigerator.
WATER LINE
CONNECTION NUT
INSTRUCTIONS
COMPRESSOR COVER OF
REFRIGERATOR
Removing any residual matter inside the water supply line after installing filter.
1.Turn ON the main water supply & turn OFF the valve to the water supply line.
2.Run water through the dispenser until the water runs clear (approx. 1L). This will clean the water supply system and remove air from the lines.
3.Additional fl ushing may be required in some households.
4.Open the refrigerator door and make sure there are no water leaks coming from the water fi lter.
A newly installed water fi lter cartridge may cause water to briefl y spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation.
UP SETTING 01
-Using clip ”A”, fi x the water line to the wall (the back of refrigerator).
-When the water line is secure, make sure whether the water line is not excessively bent, pinched or squashed.
CLIP A
WATER LINE
setting up _15
2012.3.5 3:24:50 PM |