Samsung SBB-HRCA/EN manual Package Contents, Ports, Using a HDBase-T, HDBase-T Installation Guide

HDBase-T Installation Guide

Package Contents

NUnpack the product and check if all of the following contents have been included.

Quick Setup guide	Warranty Card	HDBase-T	Bracket
	(Not available in some locations)

Ports

SERVICE	: Update SUB MICOM.
	* SUB MICOM controls IR, RS232C and POWER.
LAN	: Send Internet signals to other products.
	Ensure the HDBT IN port is connected to HDBaseT(TX).
	Ensure the HDBaseT(TX) is connected to internet.
HDBT IN	: Connect to Internet or transmit video content through a LAN cable.
	* Ensure HDBase-T (Rx) is connected directly to HDBase-T (Tx) via a
	LAN cable.
RESET	: Restart HDBase-T.

FFC Cable Screw (M4 L6) 4EA Screw x (M3 L6) 4EA

Using a HDBase-T

1.HDBase-T (Tx) transmits data from an external device to HDBase-T (Rx). Make sure to connect them directly using a LAN cable.

*Data transmission is not available if HDBase-T (Rx) is connected to HDBase-T (Tx) through a hub.

2.After installing and connecting HDBase-T, power on the display device.

3.Press the SOURCE button on the remote control provided with the display device. Next, select Plug In Module.

HDBase-T works with unshielded twisted pair (UTP) or shielded twisted pair (STP) cables; but, to ensure CE compliance, STP cables and STP Connectors are required.

Shielded cable and connectors are recommended to safeguard against unpredictable environmental electrical noise which may impact performance.

It is recommended to use an STP cable to maximize performance. Using a UTP cable or patch may decrease performance.

BN68-03137J-00