![](/images/new-backgrounds/1130785/1307859x1.webp)
•Be sure to check dangers, which may occur due to damped floor, ungrounded power extension cable, worn power cord or lack of safety grounding.
Caution
When cleaning this unit, be sure to wipe with a dried cloth. If the unit is heavily contaminated, wipe it with a soft cloth dampened with a mild detergent solution, then wipe dry with a soft clean cloth. Do not use chemicals such as alcohol, benzene, or thinner because a chemical reac- tion could result permanent damaging of the cabinet surface.
Chapter 3. Connecting with
Other Equipment
You can use the
DVR, MULTIPLEXER, and the other equipments.
This chapter describes how to connect each equipment.
Checking Contents & Accessories
On buying a product, unwrap it first and put it down on a plane or where you want to use it. Then, you shall check if the following are contained in the box.
-Main Body
-User’s Manual
Adjusting System Keyboard Angle
You may adjust the angle of the product as shown below.
Fixing Power Cord
Connecting RS-485 Device
-Connect
-You are able to install and control the camera, DVR, and multiplex- er supporting
-Either Half Duplex or Full Duplex method is applicable for connec- tion.
•For the Half Duplex method, use Tx
•To connect
•Please refer to
1) Connecting the SAMSUNG Dome Camera
AC 24V |
OUT |
Hang the power cord as shown in the following figure to prevent it from being deviated when you connect it with the main body.
IN GND IN
POWER
TxdRxd
VIDEO OUT
ALARM OUT | ALARM IN |
1 2 G NC C NO G 1 2 3 4 G |
TxdRxd
-Connect with
•In case of connecting with Half Duplex
-Connect the Txd (+) of Dome Camera
-Connect the Txd