《17》
PTZ Mode
(3) SWING
■This menu is for setting the camera to alternate between two assigned locations horizontally (pan) or vertically (tilt).
Setting the SWING SETUP menu by controllers is only possible in the SPD series. In case of products by other
manufacturers, the setting has to be done by the OSD menu of the camera. See the camera manual for more
information.
(3-1) SWING Setup
①At the [PTZ SETUP 1 ▶] menu, press the 2 button (see p.15).
②Press the 1 or 2 button to select a horizontal (pan) or vertical (tilt) cycle.
③Set starting point, ending point, movement speed, and stop time.
- I▶/▶▶button: Moves between items.
- 1ST : Starting point. Can be set for Preset 1 ~ 64.
- 2ND : Ending point. Can be set for Preset 1 ~ 64.
- SPEED : Movement speed. Can be set for 1 ~ 64 (see p.35).
- STOP : Stop time at the starting point and ending point.
Can be set to 1 ~ 99 (seconds).
④Press the ENTER button to finish the setup (takes 2 or 3 seconds to
finish).
▤The Swing function cannot be set if an unassigned number or a
number outside the selectable range is entered.
▤Over 2 PRESET locations have to be set before setting SWING.
(3-2) SWING Operation
①At the initial screen, press the Swing button.
②Press the 1 and 2 buttons to perform the Swing function.
- 1 button: Performs the horizontal cycle (pan).
- 2 button: Performs the vertical cycle (tilt).
▤Move the joystick or press a controller button during the Swing
operation to stop the operation.
▤AUTO-PAN is performed automatically when the SWING button of
PANASONIC(WV-CS854A) and SAMSUNG ELECTRONICS
(SCC-641/643) cameras is pressed.
SWINGSETUP
IST
00 2ND
00 SPEED
00 STOP
00
Enter:SwingSet
PTZCONTROLSYSTEM
CAMID: 5SPD
1:PAN 2:TILT
PressNumericKey
SWINGSETUP
CAMID: 5SPD
1:PANSET 2:TILTSET
PressNumericKey
SWINGSETUP
CAMID: 5SPD
1:PANSET 2:TILTSET
PressNumericKey