《25》
DVR Mode
DVR MODEL Setup
■This menu is for setting the DVR ID and model for operation by a
controller. Sub-controllers cannot be used if the master controller is
in Setup mode.
①At the initial screen, press the FUNCTION button and press the 0 button
to activate the [SETUP SYSTEM] menu.
②Press the 2 button to activate the [DVR SETUP] menu.
③Press the 1 button to activate the [DVR Model SETUP] menu.
④Press a number on the number pad to set the DVR ID.
The DVR model name saved in EEPROM will be displayed on the LCD
monitor when changing DVR ID.
⑤Press the + and - buttons to change the DVR model name
(SVR 430 →SVR 900 →SVR 1620 →SVR 1630).
⑥Press the ENTER button to finish the setup.
▤When connecting to an SVR-430, the SVR-430 system ID must be set to be the same as the controller DVR ID
(Menu →Network/Communication →RS422/485 →SYSTEM ID).
▤When connecting to an SVR-900/1620, the SVR-900/1620 system ID must be set to be the same as the
controller DVR ID (Menu →System Setup →Com Port Setup →SYSTEM ID).
▤When connecting to an SVR-1630, the SVR-1630 keyboard control address must be set to be the same as the
controller DVR ID (Menu →System Setup →Misc.). Also, for the SVR-1630 COM2 RS422/485 menu (Menu →
System Setup →Serial Port), Device must be set to SCC-3000 and Interface to RS-485, and for the COM4
RS422/485 menu (Menu →System Setup →Serial Port), Device must be set to SPD2500 (if an SPD2500 is
connected) and Interface to RS-485.
▤When controlling a PTZ camera via an SVR-1630, connect the SVR-1630 and the controller to COM2 RX+/RX-
and connect the SVR-1630 and PTZ camera to COM4 RX+/RX-. Also, at the SVR-1630 channel setup menu, set
the PTZ port of each channel to COM4 and set the PTZ address to be the same as the PTZ camera ID.
SETUPSYSTEM
1:PTZ 2:DVR
3:CONTROLLER
PressNumericKey
DVRSETUP
1:DVRMODELSETUP
PressNumericKey
+,
-
:ModelChange
DVRMODELSETUP
DVRID: 0[0]
MODEL:NONE
+,
-
:ModelChange
DVRMODELSETUP
DVRID: 1[1]
MODEL:SVR430
When entering '1'