User’s guide
※Note : If SW1 (AGC) is set to OFF, the Day & Night function does not work even if SW3 is positioned to ON.
E4) SW4(AWB)
If set to ON, it automatically adjusts the image color according to the temperature change of the lightning color. Under a very irregular lightning condition (such as car headlight), if set to ON, it captures a subject normally (white) and if set to OFF, it remembers the then normal color temp to operate at a certain white balance level. Note that AWB can cause an error in the following conditions. First, if a big subject of a uniform color with a high saturation exists in the center of the screen or if few part of the image is in white. Second, if the lightning is made of special material like sodium.
⑦DC IRIS Level Bar
If the ALC lens selection switch is set to DC, use a screwdriver to adjust the iris level on this bar.
※Note : - The IRIS range of the DC lens is about between 80IRE and 120IRE. In other words, the DC lens adopts a variable range limitation system, rather than IRIS Full Open/Close system.
-Depending on the type of the lens used that allows setting the value below 75 IRE may cause IRIS hunting. Therefore, make sure that the range is set to an appropriate level (higher than 80 IRE).
⑧Video Out Port
Connected to the Video Out port of a monitor. The video signal is output via this port.
24
