_03
ENG
FUNCTION
1 Protective Film over Front Glass : Remove this film before operating the Camera.
2 Focus/Zoom Lever Bolt Screws : Used to fix the Focus/Zoom ring to the lens internally.
Be careful not to lose this small bolt screws which need not be touched other than by a
service technician.
3 Focus/Zoom Ring Fixing Screws : Used to fix the Focus/Zoom Ring at the desired
position after adjusting the lens angle and focus setting as described below.
4 Focus and Zoom Ring : These two rings are used to accurately adjust the viewing angle
and to sharply focus all objects within the lens field of view.
- Loosen the fixing screws ( 3 ) to turn the Zoom and Focus ring.
i) To widen the viewing angle turn the “Zoom Ring” to “W” (Wide).
ii) To obtain a closer view turn this ring to “T” (Tele).
- After adjustment of the viewing angle then adjust the “Focus Ring” between “N” (Near) or “ ”
(Far) until the sharpest focus is achieved.
- Then tighten the fixing screws ( 3 ) on each ring.
- After tightening you should check that angle and focus is still accurate.
5 DC Level Volume Screw Cap :
- Loosen the DC level volume screw cap on the camera body.
i) For a brighter screen turn the DC level volume slowly toward “H” (counter-clockwise),
ii) For a darker screen turn it toward “L” (clockwise) with a driver.
6 Bracket : Used to install the camera to the desired location.
function & installation
1
45
3
2
6
[THE OTHER SIDE VIEW]
VIDEO
POWER
01-SCC_B9372_EU-ENG.indd 3 2008-03-10 오후 3:57:56