CAMERA MENU Organization

The DIS feature is unavailable while setting the AUTO slow shutter.

If you set SHUTTER to between AUTO X4... and AUTO X128..., FOCUS mode will be displayed as “MF”(the product can operate only in MF mode). You can’t adjust the settings manually.

If you set it to OFF, 1/100 ~1/10K or AUTO X2..., the product will recover the previous

EFOCUS mode.

If you set SHUTTER to between AUTO X2 and AUTO X128, DIS will be displayed as

“---“ (it can only operate in Off mode). You can ’t adjust the settings manually. If you set it to OFF or 1/100 ~1/10K, the product will recover the previous settings of DIS.

AGC/MOTION

In the AGC (Automatic Gain Control) option, you can specify whether to automatically control the GAIN when the obtained video is below a certain level of brightness because it was recorded under insufficient lighting. To automatically control the GAIN, set the AGC option to LOW or HIGH. Otherwise, set it to OFF. If the you set the AGC option to LOW, the maximum GAIN of the AGC will be set to low, and if set to HIGH, the maximum GAIN will be set to high.

If the SHUTTER is in AUTO mode, AGC is switched to MOTION.

In MOTION, use the [left,right] key to select “S.SLOW / SLOW / NORMAL / FAST / F.FAST”.

 

CAMERA ID

ON...

 

IRIS

ALC...

 

SHUTTER

OFF

 

AGC

 

LOW

 

WHITE BAL

ATW1

 

FOCUS MODE

ONEAF

 

ALARM SET

...

 

COLOR/BW

COLOR...

 

PRIVACY

ON...

 

SPECIAL

...

 

PRESET

...

 

EXIT

QUIT

 

 

 

 

<AGC>

WHITE BAL

You can select one of four modes for white balance adjustment as follows:

 

- ATW1/ATW2(Auto-Tracing White Balance Mode): In these modes, the color

 

temperature is monitored continuously and thereby white balance is set automatically.

 

E

The following are the approximate supported color temperature ranges in these modes.

 

 

ATW1 : 2500K

~ 9300K(* 1)

 

ATW2 : 2000K

~ 10000K(Mode recommended for sodium lighting)(* 2)

 

*1. If the color temperature is out of this range in ATW1 mode,proper white balance may not be obtained. In that case, select ATW2 mode.

*2. In ATW2 mode, if one color is dominated in the shooted area, the color can be displayed differently. Therefore, select the mode which is appropriate for the

environment.

-AWC(Auto-Tracing White Balance Control): In this mode, accurate white balance is obtained by pressing [ENTER] while having a white paper in front of the camera. White Balance data will be maintained after set it once. AWC mode is best in locations where the color temperature of light source is constant.

-MANU : If WHITE BAL menu is set to MANU mode, the user can set the white Balance considering the current illumination. Select MANU item and press [ENTER], the sub screen where you can select Manual White Balance will be shown. Use the left/right keys to select 3200K, 5600K or OFF(USER) mode in the PRESET

menu.

*3200K : Set color temperature to 3200K

*5600K : Set color temperature to 5600K

*USER : Choose out a proper value from the RED and BLUE graph for color and temperature setup.

34

35