Samsung SDC-415 instruction manual When using a C-Mount lens, When using a CS-Mount lens

Installation

3.Please remove the cover of the auto iris lens connection plug and solder the lens cable to the connector pin in the plug.

Pin No.		LENS
	DC	VEDIO
No.1 Pin	Damping-	Red(power)
No.2 Pin	Damping+	NC
No.3 Pin	Drive+	White(video signal)
No.4 Pin	Drive-	Black(GND)
		Lens cable
No.3 Pin
No.1 Pin		Connector

No.4 Pin

No.2 Pin

4.Please replace the auto iris lens connection plug cover and take off the lens protection cap, and then attach the auto iris lens to the camera by screwing it in clockwise.

5.Please insert the connection plug that is connected to the auto iris lens cable into the auto lens connector, which is located on the side of the camera.

When using a C-Mount lens

Please take off the lens protection cap and attach the C-Mount lens to the camera by screwing it in clockwise.

C-mount adaptor

When using a CS-Mount lens

1. Please take off the lens protection cap and C-mount adaptor.

C-mount adaptor

Lens protection cap

2. Please attach the CS-Mount lens to the camera by screwing it in clockwise.

C-mount adaptor

Note

•Please use the specified lens connection parts as shown in the picture below. The use of the wrong sized parts of the wrong size may cause

damage to the inside of the camera or result in poor fitting.

6. Please set the lens selection switch, located on the side of the camera, to DC or VIDEO depending on the type of auto iris lens which is being used.

•Use of a lens which is too heavy affects the balance of the camera and may cause a malfunction. Please use a lens that weighs less than 450g.

•Please select Av mode if possible when adjusting the automatic light control (ALC) of an auto lens. Use of PK mode may cause hunting.

C-mount lens : 10 mm or less

CS-mount lens : 5 mm or less

COLOR CCD CAMERA 16 User’s Manual COLOR CCD CAMERA 17 User’s Manual