Instruction: Camera Operation
SSNR
Low light noise is reduced in different ways depending on the mode; the noise reduction level changes from none to maximum as the mode changes from Off to Low, Middle, and High.
1. After the Setup menu is displayed, press the Up/Down buttons to move the arrow to “SSNR.”
SETUP |
|
CAMERA ID | OFF |
BACKLIGHT | OFF |
WHITE BAL. | ATW |
MOTION DET. | OFF |
LENS | DC |
SHUTTER | MANUAL |
AGC | HIGH |
OFF | |
SSNR | MIDDLE |
SPECIAL |
|
EXIT |
|
2. Press the Left/Right buttons to select a mode.
Off | : No noise reduction |
Low | : Low noise reduction with almost no ghost image |
Middle : Probably the most practical mode, with enough noise reduction and not too much ghost image
High : Maximum noise reduction, but the ghost image increases as well
Caution
• When AGC is Off, the SSNR &
COLOR CCD CAMERA 32 User’s Manual
Special
1.After the Setup menu is displayed, press the Up/Down buttons to move the arrow to “Special.”
2.Press the Left/Right buttons to select a mode.
Privacy : Masks selected areas from the screen
- Off | : Off |
- On | : Privacy mode is currently On |
•Press the Set button
•Select an area to mask from the 4 areas in Area Sel
•Change the Area State of the selected area to On
•From Area Tone, press the Left/Right buttons to control the brightness
•Set the area size from the Top/Down/Left/Right menu, and then press the Set button.
Color | : Select Color or B/W mode |
- On | : Always provide color images |
- Off | : Always provide images in B/W If you press ‘SET’, a menu will appear in which |
| you can turn the BURST signal ON/OFF. |
| By adjusting ON/OFF, you can maintain or eliminate the BURST signal. |
- Auto : Use color and switch to B/W only when illumination level gets very low | |
- Exit | : The filter can be changed by signals from external devices. |
COLOR CCD CAMERA 33 User’s Manual
