7.Make sure that the bracket-HDD is mounted stably inside of the product, then connect the power supply cable, signal transmission cable (IDE cable), and fan cable to the HDD.

8.Check if there is any problem with connector or wiring inside of the product for connecting and mounting then close the cover.

9.Tighten cover mounting screws. (The left and right side each has 5 spots and back side has 1 spot)

Caution

1.When mounting an additional HDD, the primary master has to be mounted.

When adding one – Primary slave (mount on the top of the bracket that has a built-in HDD

when coming out of the factory.)

When adding two – Secondary master (mount under the bracket that is empty when coming out of the factory.)

When adding three – Secondary Slave (mount on the top of the bracket that is empty when coming out of the factory.)

2. Mount the HDD you want to add after setting the master/slave jumpers in the proper order.

English 2-8