Samsung SHR-3040 BeFOre start

4_ overview

overview

BeFOre start

This user’s manual provides Information for using DVR such as brief introduction, part names, functions, connection

to other equipment, menu setup, and the like.

You have to keep in mind the following notices:

Samsung retains the copyright on this manual.

This manual cannot be copied without Samsung’s prior written approval.

We are not liable for any or all losses to the product incurred by your use of non-standard product or violation of

instructions mentioned in this manual.

If you want to open the case of your system for checking problems, please consult the expert from the shop

where you bought the product.

Before installing or replacing the HDD, or connecting a USB memory device to the DVR, check if it is compliant

with the DVR. For the compatibility, contact the retailer where you purchased the product.

Exchanging a wrong battery in your product may cause an explosion. Therefore you must use the same type

of battery as the one being used in the product.

The following are the speciﬁcations of the battery you are using now.

Normal voltage: 3V

Normal capacity: 220mAh

Continuous standard load: 0.2mA

Operating temperature: -20°C ~ +85°C (-4°F ~ +185°F)

Connect the power cord into a grounded outlet.

The Mains plug is used as a disconnect device and shall stay readily operable at any time.

Batteries shall not be exposed to excessive heat such as sunshine, ﬁre or the like.

Turning off the power while the product is in operation, or taking not permitted actions may cause damage to

the hard drive or the product. Also it can cause a dysfunction to the hard disk while using the product.

For safe power disconnection, select <sHutDOwN> in the DVR menu and remove the power cable.

You may want to install a UPS system for safe operation in order to prevent damage caused by an

unexpected power stoppage.

(Any questions concerning UPS, consult your UPS retailer.)

The guaranteed operating temperature range of this product is 0°C ~ 40°C (32°F ~ 104°F).

This product may not work properly if you run right after a long period of storage at a temperature below the

guaranteed one.

When using the device after a long period of storage at low temperature, place the product at room

temperature for a while and run it.

Especially for the built-in HDD in the product, its guaranteed temperature range is 5°C ~ 55°C (41°F ~ 131°F).

Likewise, the hard drive may not work at a temperature below the guaranteed one.

❖

02489A_SHR-3040_ENG.indb 4 2009-11-10 오후 2:12:49