Your Combo Drive
1 | 2 | 3 | 4 | 5 | 6 |
1.Earphone connection terminal
2.Volume control
3.Indicator light (when it is green, a disc is being read or recorded)
4.Disc compartment
5.Emergency eject hole (if the compartment does not open when you press the Eject button, insert a pin or unfolded paper clip in the hole and push firmly)
6.Eject button
1 | 2 | 3 | 4 | 5 |
1.Digital output terminal
2.Sound output terminal
3.Master/slave select terminal
4.Interface terminal
5.Power terminal
4
Upgrading the Firmware Flash Memory
The product firmware can be upgraded by downloading the updated file from the following Web site:
http://www.samsungelectronics.com
System Requirements
Before you install the COMBO drive, we strongly recommend that you check that your setup meets the system requirements listed below.
Item | Description |
Computer | Intel Pentium II 300MHz/Celeron 333A(or higher), |
| 32 MB of RAM (or higher) with an IDE interface |
|
|
Free expansion unit | 5.25 inch |
|
|
Disk space | 700 MB minimum |
|
|
Windows version | Windows 95/98/2000/ME/NT4.0 OSR2 (or higher) |
| (For Windows NT, we recommend Service Pack2, |
| and Version is over 4.00.1381) |
|
|
| 5.0 or higher (For |
| can only read a disc without premaster Software.) |
|
|
DVD Video playback | PC with Windows 95/98/2000/ME/NT4.0 OSR2 |
| |
| (the Power DVD MPEG software is included in the |
| COMBO drive package) |
Installing the COMBO Drive
To install your COMBO drive in the PC, proceed as follows.
1 Make sure that the PC is powered off and disconnected from any power source.
2 If necessary, attach a horizontal bracket to both sides of the drive.
●Use of the brackets depends on your computer
model; you can purchase these accessories separately from your computer dealer.
3 Remove the cover from a free expansion slot and install the COMBO drive, as shown in the illustration.
● If you have no free expansion slot, install the drive in place of the diskette drive.
COMBO drive
5
