Connecting the Cables

1. Power cable

2. Master/slave select terminal

You already have an additional IDE device installed in your computer.

Second IDE cable

First IDE cable

3. IDE cable

4. Audio cable

1 Connecting the power cable

The 4-pin power cable from the internal power unit of your computer must be connected to the power terminal on the rear of the COMBO drive.

COMBO CD-ROM

(MA) (SL)

Mother

board

Hard disc

Hard disc

(SL)

(MA)

2 Installing a jumper on the master/slave select terminal

Install the jumper in the correct position on the terminal:

MA to use the device in the master mode

SL to use the device in the slave mode CS to control the device via a CSEL

host interface signal

See Step 3 for further details.

3 Connecting the IDE cable

Two configurations are possible.

The COMBO drive is the only IDE device in addition to the hard disc.

IDE port

Mother board

COMBO Hard disc

(SL) (MA)

Install the jumper in the SL position (Slave).

Connect the 40-pin flat IDE cable from the IDE port on the mother board, first to the COMBO drive and then to the hard disc.

Install the jumper in the MA position (Master).

Connect the 40-pin flat IDE cable from a second IDE port on the mother board directly to the COMBO drive or first to another additional IDE drive and then to the COMBO drive.

4 Connecting the audio cable from a sound card

Connect the 4-pin audio cable between the sound output terminal on the COMBO drive and the audio input terminal on the sound card.

6

7

Page 5
Image 5
Samsung SM-308 manual Connecting the Cables, Connecting the power cable