6.9

5.5

4.1

9.2

30.1

7.1

5.7

4.3

9.6

31.4

7.4

5.9

4.4

9.9

32.4

7.6

6.1

4.6

10.2

33.4

2.Select one from Front-Floor, Front-Ceiling, Rear-Floorand Rear-Ceilingaccording to the location to install the projector.

3.Set the values of the H-Keystoneand the V-Keystoneto '0' and place the zoom knob right in the middle of its movement range.

4.Press the MENU button to display the Crosshatch screen of the Test Pattern. (Setup → Test Pattern → Crosshatch)

5.Adjust the location of the projector until lines ① and ② in the picture below become parallel.

Screen

Crosshatch Test Pattern

① A virtual vertical line made on the screen using a piece

② A vertical line in the middle of the Test Pattern

of thread, etc.

 

6. Adjust the projector's angle so that a corner of the projected picture (which is nearest to the projector) meets that of the screen.

A : Projector

B : Screen

C : Projected image

D : A corner of the picture nearest to the projector

→

Adjust the projector's angle until the projected image covers the entire screen area

(The projected image may not cover the entire screen area depending on the projector's installation height. In this case, adjust the projector's angle so that the entire screen area can be covered.)

7.Press the V.KEY-STONE button on the remote control. The V-Keystonemenu will be displayed. Adjust V-Keystoneusing the + or - button on the remote control.

- A : Projector - B : Screen - C : Projected image