Fixing the PDP panel to the wall attachment panel bracket
1 Remove the screws from the back of the PDP.
2 Connect insulation holders to screws (see the illustration below).
• If you are uncertain about installation, hire a specialist to install the wall mount bracket.
• Be sure to check that the insulation holders are completely secured on both the left and right side after hanging the PDP on the wall mount bracket.
• Be careful to avoid getting your fingers caught during installation.
• Make sure the wall attachment panels are tightened. Otherwise the PDP may fall.
3 Tighten the screws of the insulation holders to the back of the PDP.
Note
• A 5 inch gap is needed between the back of the Plasma TV and the wall.
11
