Rev. 1.04 - 39 -
SRP-275
11-3 The printer stops printing • If the ERROR LED is on (but not blinking), the printer is off line. Check to see that the covers are closed
and check the paper state. See Chapter 5 for instructions on installing or replacing the paper roll.
• If the ERROR LED is blinking, there is an error. In this case, turn off the printer for a few seconds and then
turn it back on. If the LED is still blinking, call your supervisor or a service person.
• Turn off the printer and check for a paper jam. To clear paper jam, follow the steps below:
1) Turn off the printer and open the rear cover of the printer.
2) Remove the jammed paper and reload the paper roll as described in Chapter 5.
3) Close the rear cover.
4) Turn on the printer.
• Self test
Try to run the self test to check that the printer works properly. See the self test instructions in Chapter 8
to run the self test. If the self test does not work, contact your supervisor or a service person.
If the self test works properly, check the following:
1) Check the connection at both ends of the interface cable between the printer and the computer. Also
make sure that this cable meets the specifications for both the printer and the computer.
2) The data transmission settings may be different between the printer and computer. Make sure that the
printer’s DIP Switch settings for data transmission are the same as the computer’s. You can see the
printer’s interface settings on your self test printout.
NOTES
If the printer still does not print, contact your dealer or a qualified service person.
Check the state of ribbon cassette. If the ribbon cassette life ends, replace the ribbon cassette as
described in Chapter 4.
NOTES
If the printer is still poor, contact your dealer or a qualified service person.