Rev. 2.01 - 12 -
SRP-370/372 Ver.2
1-4-2 Parallel & USB Interface
Switch No. Function ON OFF Default
SW2-1 OFF
SW2-2 OFF
SW2-3 Select Print Density * Refer to below Table OFF
SW2-4 Historical Control Enable Disable OFF
SW2-5 Reserved -- OFF
SW2-6 Interface Condition
Selection by Memory
Switch by DIP
Switch OFF
SW2-7 Near End Sensor Status Disable Enable OFF
SW2-8 Printing width 2” Printing 3” Printing OFF
DIP switch Setting 2 Function
SW 2-1 SW 2-2 SW 2-3 Print Density Remark
ON ON ON 130%
OFF ON ON 120%
ON OFF ON 110%
OFF OFF ON 105%
OFF OFF OFF 100% Default
ON OFF OFF 95%
OFF ON OFF 90%
ON ON OFF 80%
Select Print Density
1-4-3 Auto Cutter Enable / Disable selection
Dip Switch Set 1
SW 5 ON Auto Cutter Disabled
Application Ignores Auto Cutter error for continuous printing.