initialization
OUTPUT FORMAT
You can adjust the output format of the numeric values from the keypad.
You can select 4/8 bit Burst or 26bit Wiegand.
Adjust the format according to the controller receiving the keypad input.
1. To change the output format, use the switch on the rear of the
product. | ON |
|
|
|
|
1 2
2. See the table below to make adjustment as needed.
❖Output Format
SW #1 | SW #2 | Output Format of Card | Output Format of Keypad |
|
|
|
|
ON | ON | 26bit Wiegand + | 8bit Burst (Default) |
|
|
|
|
ON | OFF | 26bit Wiegand + | 26bit Wiegand + |
|
|
|
|
OFF | ON | 26bit Wiegand + | 26bit Wiegand + |
|
|
|
|
OFF | OFF | 26bit Wiegand + | 4bit Burst |
|
|
|
|
M Switch #1 and #2 of SW are set to ON by default.
Before you change the output format, you must disconnected the power.
INITIALIZATION
English _ 11
