Samsung ST65W3PC, ST62T8PC, ST47W3PC Memorizing the Channels, Selecting the Video Signal-source

O P E R AT I O N

Memorizing the Channels

Your TV can memorize and store all of the available channels for both “off-air” (antenna) and cable channels. After the available channels are memorized, use the CH and CH but- tons to scan through the channels. This eliminates the need to change channels by entering the channel digits. There are three steps for memorizing channels: selecting a broadcast source, memorizing the channels (automatic) and adding and deleting channels (manual).

Selecting the Video Signal-source

Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the TV (i.e., an antenna or a cable system).

1

Press the Menu button.

Press the CH button to select “Channel”, then press the VOL + button.

	Channel
Antenna	: A
ANT/CATV	: ANT
Auto Program
Fav. Channel
Fine Tune	: 00
Add/Erase
Labeling	: - - - -

2

Press the CH button to select “ANT/CATV”, then Press the VOL + or VOL - button to cycle through these choices:

ANT (antenna), STD, HRC or IRC.

	Channel
Antenna	: A
ANT/CATV	: ANT
Auto Program
Fav. Channel
Fine Tune	: 00
Add/Erase
Labeling	: - - - -

Note: STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company to identify the type of cable system that exists in your particular area.

At this point the signal source has been selected. Proceed to “Storing Channels in Memory” (next page).

3.8 CHAPTER THREE: TV OPERATION