Connection
Connecting to RS-485 Control Cable
|
| CONTROL CABLE | SPEC |
RED(TRX+) |
| RED (TRX+) | |
|
| WHITE | |
) |
|
|
|
|
|
|
|
Using
(1)Connection to a PC.
Connect the camera to the PC via a
CONTROL CABLE
(2)Connection to a DVR or System Controller.
Connect the
485 Control Board Connection Port |
| |||||
| (+) CONNECTION TERMINAL | RED (TRX+) |
| |||
| WHITE |
| ||||
* |
|
|
| |||
|
|
|
|
|
|
|
Item | Camera ID | BAUD RATE |
| UART MODE |
| RET PKT |
Initial value | 1 | 9600 |
|
| ENABLE |
Notes
•When building a control system to control the camera, please use to the STW(SPD)PROTOCOL or
•When you connecting to
•In case of
『Communication configuration』menu. (For more information, refer to
Using Coaxial Communications
•Coaxial Communications System
•OSD Control method
CAMERA | DVR | CONTROLLER |
SET | MENU / ENTER | OSD KEY |
UP | UP KEY | JOYSTICK UP |
DOWN | DOWN KEY | JOYSTICK DOWN |
LEFT | LEFT KEY | JOYSTICK LEFT |
RIGHT | RIGHT KEY | JOYSTICK RIGHT |
|
| DVR |
|
| DVD |
• : BNC
•
–Video Cable
The camera's video output port is connected to the monitor with a BNC coaxial cable, shown below : If the distance between the camera and the monitor exceeds the recommended maximum, please use an auxiliary video amp.
Distance | Recommended Cable Specification |
300m | |
450m | |
600m |
Notes
• If the camera is controlled through coaxial communication, please use a video amp intended for coaxial communications. Regular video amps do not transfer coaxial signals.
COLOR DOME CAMERA 14 User Guide | COLOR DOME CAMERA 15 User Guide |