Samsung SVR960NRT MAINTENANCE, TROUBLESHOOTING, When the screen does not show a good picture, Won't record, or playback, the PLAY button, No picture, Won’t record

MAINTENANCE

If the picture is not clear on the screen, use the cleaning tape.

If the cleaning tape is playbacked for a long time, it may be harmful for the head.

TROUBLESHOOTING

Check to see whether you contact service center.

No power.

	.
Won't record	or playback

1 Drop six to seven drops of head cleaning solution on the cleaning tape.

LIQUID

CLEANING

CLEANING TAPE

Insert the cleaning tape
2 into your video and press
the PLAY button.
						REC
					F.F
				PLAY	REW	P/STILL
						REC CHECK
			STOP/EJECT
		TAPE			CLEAR	RECLOCK
					HIGHPICTURE
	CLEANING				RESET
				ON COUNT	CNT.MEMO
			AUDIO
		REV
	REC LOCK
POWER	HIGH
	PICTURE
	TIME MODE
	TRACKING/SET
MENU

3 After about 15 seconds, press the STOP button to stop the operation.

•Use the cleaning tape one more time when there is no normal picture.

STOP/EJECT

•Check to see whether the power cord is plugged in.•Press the RESET button on the front panel.

31

•Check to see whether the tape is inserted.•Pull out the power cord, and then insert it

.
again	button on the front
• Press the "RESET"
.
panel
31

Change the head under the following conditions

•The picture is not clear on the screen as the head is worn due to use of the video for an extended period of time.

•The head can be worn when using damaged or defective tapes or using the cleaning tape several times.

•The service life of the head varies depending upon the environmental conditions for use (temperature, humidity, dust, etc.). Replace the head when using your unit for more then 3,000 hours.

When the screen does not show a good picture

1.First press the TRACKING button.2.Check to see whether the video output is properly connected.

3.Insert the cleaning tape. When the screen image is not improved even after repeating the above procedures, contact your dealer or service center.

					.
No picture
• Check to see whether		the input selection				of the
				.
monitor is properly	connected						on the
			the video input/output
• Check to see whether
						.
rear side of the unit are				properly	connected			to
• Check to see whether			the power is connected
.
the VCR

			Won’t record.
•
Check to see whether the
Use a tape with an				safety tab is removed				from the tape.
			attached safety tab. If the
removed from							safety tab has been
		the tape, attach
					scotch tape to it for recording.
• Check to see whether the
				tape has
Replace the					come to its end.
•	tape or rewind the tape.
Check to see whether the				P/STILL button		has been pressed.
Release the
	P/STILL button.
• Make
sure time and date on VCR
					are set (Refer to Recording)

MAINTEN- ANCE

39 40