ASSEMBLING THE RAT PROTECTION PANEL 
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1. It is easier engaging the shutter when | 2. Insert the shutter completely through the | ||||||||||||
the set is lifted up a little, as shown in the | engagement hole from the back. | ||||||||||||
figure below. |
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
HOW TO PUT THE DETERGENT IN
1.Open the detergent box by pulling in the direction of the arrow as shown in the
figure and then put the powder detergent in the detergent box.
2. Put in
HOW TO ADD THE FABRIC SOFTENER
Slide and open the cover in the direction of the arrow, insert the rinse detergent, and slide and close it in the reverse direction.
•When a proper amount (one time does) of fabric softener is stored in the softener inlet,it is automatically put in at the last rinsing cycle.
• Do not use detergent, bleach or starch into the Softener Inlet.
•Using too much softener may produce unsatisfactory results.
•Do not open the lid during the Spin Dry cycle. If added too early, its effectiveness will decrease.
•Do not leave the softener into the Softener Dispenser for a long time. Because softner became stiff.
WATER SUPPLY CONNECTOR FILTER
1. Pull out the filter and wash well.
2.Pull in the filter and connect the hose to the inlet water
valve tightly.
3.Check if there is a leakage.
Note to tighten up the connector.
03 INSTALLATION & MAINTENANCE
installation & maintenance _19
