setting up your washer

HOW TO WASH AUTOMATICALLY DEPENDS ON THE LAUNDRY

Before starting washing, check the following;

Connect the water supply hose to the water tap. Leave a tap open. Plug the power cord in. Make sure to lay down the drain hose.

Washing for the first time

Before washing clothes for the first time, you must run a complete cycle without clothes. To do this:

1.Press the Power button.

2.Open the detergent drawer and insert a little detergent.

3.Turn on the water supply to the washing machine.

4.Press the Start/Pause button.

This will remove any water from the manufacturer’s test run remaining in the machine.

Special notes!

Clothes loading order

When loading the clothes into this machine ensure the following loading order is used for maximum washing effectiveness T shirts, bath towels, table cloths, business shirts, bed sheets, pillow cases, under shorts, wash cloths then finally handkerchiefs.

Automatic Sensing Function

At every program (except wool program) the amount of laundry is automatically sensed and then appropriate water level, washing time, rinsing cycle, and spinning time are automatically selected for automatic washing.

After the power is on, a program is selected and Start/Pause button is pressed. Then, the washing board starts spinning without water. This action senses how much laundry is in the washing basket, not a machine problem. After this sensing process, water supplies automatically.

Adding Detergent and Softener

It senses the amount of laundry and indicates the water level and amount of detergent. Then, it starts water supply right away.

During the water supply, it is possible to open the detergent box and add detergent. However, it is better to press Start/Pause button to stop water supply and add detergent. Close the lid and press Start/Pause button again. This way is much more convenient.

If the softener is inserted in the softener dispenser, it automatically adds in at the last rinsing cycle.

Put the laundry into the washer and add detergent, too.

Be careful not to overload. Use right detergent for the fabrics you are washing.

If the lid is open while running, the washing machine is stopped automatically for safety. (Except, water supply continues while the lid is open.)

When hot water is selected, both cold and hot water are supplied for the first 20 seconds in order to protect the clothes.

Possible to control the washing time, rinsing cycle, and spinning time at every program during the washing.

10_ setting up your washer

Page 10
Image 10
Samsung SW65V9W, SW75V9W HOW to Wash Automatically Depends on the Laundry, Washing for the first time, Special notes