DESCRIPTION AND / CLEANING OF PARTS
.
CLEANING THE FILTER•Pull the overflow filter out and take up
(with pump)
OVERFLOWFILTER LINT FILTER This is used for gathering the dregs made during washing.WASH TUB LIDBe sure to keep the lid closed during washing and spinning.
lid while the spin basket is spinning,the spinning will be stopped by the brake system.
SPIN DRYER BASKETPOWER CORD The plug’s shapemay not be similar to that shown in this drawing.
WATER DRAIN HOSE
(without pump)
EARTH WIREthe filter by removing 3 screws as shown in figure. Wash the filter and washing tub.
•Push the strainer(filter) out and take
up the filter as shown in figure. Wash the filter and washing tub.
DRAIN FILTERIn case of incomplete drain, disassemble the drain filter with screw driver(+), and remove lints from the filter as shown in the filter as shown in
the figure.
HOW TO CLEAN THE FILTER (In case drain pump)PULSATOR |
| WASH TUB |
|
|
|
| |
|
| DRAIN FILTER |
|
OVERFLOW FILTER | CLEANING THE LINT FILTER | OVERFLOW FILTER |
|
• Pull the upper side of the | • If the dregs are piled up in the | Pull the upper side of the | A |
overflow filter with your | lint filter after finishing the wash, | overflow filter with |
|
fingers into the holes | push down and | two fingers inserted into |
|
in the direction of | pull it out as | hole ‘A’ in the |
|
arrow as shown | shown in the | direction of arrow |
|
in the figure. | figure. | as shown in the figure. |
|
| • Wash the filter |
|
|
| net in water. |
|
|
1.Place a rag under the washer filter not to wet the floor.
2.Rotate the filter counterclockwise and pull out the filter.
3.Remove dirts and
rotate the filter clockwise until it locks in position.
First, fill water in the wash tub to ‘L’ level(, then drain water from the wash tub simultaneously with operating wash cycle for 1~2 minutes. • Close the wash tub lid.
2