Samsung SWT50B1IW/YAJ, SWT50B1IW/YFE, SWT50B1NW/YL Control Panel, Before Using TH Washing Machine

WATER SELECTOR

Wash Spin

BEFORE USING TH	E WASHING MACHINE	CAUTIONS
• Remove the cap-hose		• Be sure that the washer is grounded.
from the drain hose.		To avoid electrical shock,use a
		metal pipe for the ground
• In the case of pump drained		connection. But, don't ground the
		washer with gas pipes or telephone
washer, remove		lines to avoid to dangers of explosion
the cap-hose from		or lightning strike.
the drain hole.		• Do not put your hands into the
		spin dryer basket when it is
		spinning.
PRECAUTIONS W	HEN OPERATING	Your fingers can be caught by
		spinning laundry and damaged.
• Don't use excessively hot water.		• Never allow children to operate
(50˚C or more)		or play with the washer.
Plastic parts may be deformed or damaged.		Children playing with the
Also, clothing may be deformed or decolored.		washer may accidentally
• Before washing,check all pockets.		fall into the washing tub.
		• Disconnect the power cord from the
If nails or pins remain in pockets,they may
damage the washer or clothes.		power supply when not in use.
• Close the water tap a little if the		• Ventilation opening must not be obstructed
water pressure is too high.		by carpeting when the washing machine is
• Never splash water on the control panel.		installed on a carpeted floor.
		• If the supply cord of this appliance is
• Be sure to cover with the inner
		damaged, it must only be replaced by a repair
cover on laundry before spinning.		shopappointed by the manufacturer, because
This prevents laundry from		special purpose tools are required.
being tossed out and damaged.		• Warning to avoid overfilling and damages this
• To avoid water splashes, close the
		appliance must be filled with the operator
wash tub lid.		present using a moderate water supply
• Be sure laythe drain hose down.		pressure only.
		• Do not store or use gasoline or other flammable
(in case no drain pump)
		vapors and liquids in the vicinity of this or any
		other appliance.
		• To avoid overfilling and damages this appliance
		must be filled with the operator present using a
		moderate water supply pressure only.

CONTROL PANEL

1. WASH TIMMER		0
This is used to set the	15
			3
wash time, 1-15 minutes. 12		6
		9
		WASH TIMER

2.CYCLE SELECTOR

This is used to set the	Wash/Rinse			Wash
Washing/Rinsing		Drain Rinse			Drain
or Draining.
	CYCLE SELECTOR		CYCLE SELECTOR
3. SPIN DRY TIMER	0
	5	1
This is used to set the
spin time, 1-5 minutes.	4	2

3

SPIN DRY TIMER

4. WATER SELECTOR(FOR SW-50B1)

During washing, WATER SELECTOR KNOB should be selected.

During spin rinsing, WATER SELECTOR KNOB should

be selected.

1