21.Attach the indicated end of the Low Cable (8) to the bracket on the Rear Base (3) using an M10 x 20mm Bolt (26) and an M10 Nylon Locknut (11).
22.Make sure all parts are properly tightened before you use the weight rack. The use of all remaining parts will be explained in Adjusting the Weight Rack beginning below.
21 |
8 |
Bracket |
3 |
11 |
26 |
Adjusting the Weight Rack
This section explains how the weight rack can be adjusted. Inspect and tighten all parts each time you use the weight rack. Replace any worn parts immediately. The weight rack can be cleaned with a damp cloth and a mild,
USING THE WEIGHT ADAPTER
A Weight Adapter (42) and Pin (52) have been included for use with the WEIDER¨ PRO XT15 weight bench (model number WEBE0910).
To use Olympic weights with the weight bench, slide the Weight Adapter (42) onto the leg lever and secure it by inserting the Pin (52) through the leg lever as shown.
USING THE LOCKING BAR
Before starting an exercise, position the barbell and the Safety Spotters (23, 24) in the correct position for the exercise.
To do this, stand in front of the rack and grip the Locking Bar (34) with both hands. Turn the Locking Bar until the two hooks disengage the slots in the Uprights
(1). Raise or lower the Locking Bar to a new position and turn it until the hooks engage the slots in the Uprights. Note: Always start an exercise with the barbell positioned at the lowest point to which it will move during the exercise.
Position both Safety Spotters (23, 24) directly under the Weight Gliders (31, 32). (See USING THE SAFETY SPOTTERS on page 13.)
| Leg Lever |
| 52 |
| 42 |
| 1 |
| 1 |
31 | Hook |
| Hook |
| 34 |
| 32 |
23 |
|
| 24 |
12
