17.Slide the indicated end of the High Cable (13) onto the M10 x 20mm Bolt (26) in the Weight Carriage (22). Tighten an M10 Nylon Locknut (11) onto the Bolt.

18.Route the High Cable (13) around a Pulley (5) as shown. Hold a Cable Trap (21) against the Pulley and attach a Pulley Plate (19) to each side of the Pulley using an M10 x 45mm Bolt (40) and an M10 Nylon Locknut (11). Make sure the Cable Trap holds the High Cable in the groove of the Pulley.

Do not overtighten the Nylon Locknut; the Pulley must be able to turn freely.

19.Route the indicated end of the Low Cable (8) around a Pulley (5). Attach the Pulley to the bracket on the Base Crossbar (20) using an M10 x 45mm Bolt (40) and an M10 Nylon Locknut. Do not over- tighten the Nylon Locknut; the Pulley must be able to turn freely.

20.Route the Low Cable (8) around a Pulley (5) as shown. Hold a Cable Trap (21) against the Pulley and attach the Pulley and Cable Trap to the lowest holes in the two Pulley Plates (19) using an M10 x 45mm Bolt (40) and an M10 Nylon Locknut (11). Make sure the Cable Trap holds the Low Cable in the groove of the Pulley. Do not overtighten the

Nylon Locknut; the Pulley must be able to turn freely.

17

 

13

 

11

26

 

 

22

18

 

13

5

11

21

 

19

40

 

19

 

8

5

 

11

 

20

40

20

 

 

19

11

40

 

5

21

 

8

 

11

Page 11
Image 11
Weider WEBE19300 manual Nylon Locknut the Pulley must be able to turn freely