Samsung TAD-798 owner manual Screening Calls, Using Call Breakthrough

43-798.fm Page 15 Monday, August 16, 1999 9:33 AM

SCREENING CALLS

To screen calls, let the TAD answer, then listen to the caller’s message through the TAD’s speaker. To adjust the TAD’s volume, slide VOLUME to- ward + or – .

When a caller enters the CBT code dur- ing the outgoing message, the TAD alerts you with a series of loud beeps for 35 seconds. To answer the call, pick up the handset. If you do not answer, the caller can leave a message after the outgoing message plays.

If you do not want to take the call, sim- ply let the TAD finish recording the call- er’s message.

If you decide to answer the call, pick up any phone on the same phone line as the TAD. The TAD stops recording and resets to answer the next call.

Note: If you pick up the phone just as the TAD answers, the TAD might not stop playing the outgoing message. If this happens, press STOP.

USING CALL

BREAKTHROUGH

If you screen your calls but want to know when calls come in from certain people, give them your call break- through (CBT) code (preset to 648).

Changing the CBT Code

The CBT code is preset to 648, but you can change it by following these steps.

Note: If you do not complete each step within 8 seconds, the TAD sounds four beeps and exits setup. Start again from Step 1.

1.Hold down CODE (Co appears) until the TAD beeps once.

2.Press REPEAT. Cc (CBT code) and the digits of the current code appear in sequence, then the first digit re- appears.

For example, if the CBT code is

648, the message counter shows

Cc, –6, –4, –8, then –6.

3.Repeatedly press SKIP or REPEAT to set the first digit, then press STOP. The second digit appears.

15